Tech-source GFX 400 Series Manuel d'utilisateur télécharger pdf (Page 15)

Chapter 3 – Software Installation

3-3

2. Boot the computer with the "-r" (reconfiguration) option.

To do this on a typical SPARC desktop/server, perform

the following steps:

• Power ON the computer.

• Wait until you see boot messages displaying on the

screen, then press and hold the Stop (L1) key, and

then press the "A" key.

• At the "ok" prompt, type "boot –r" followed by the

<Enter> key.

3. After the system has booted, log in as root.

4. Insert the CD-ROM labeled "GFX 400 Series Driver

Software-Solaris Edition" into the CD-ROM drive.

5. If /cdrom/cdrom0 exists, type:

prompt# cd /cdrom/cdrom0

Skip to step 6. Otherwise, mount the CD-ROM by typing

the following:

prompt# mount -F hsfs -O -o ro \

/dev/dsk/c0t6d0s0 /cdrom

prompt# cd /cdrom

6. The CD-ROM contains an install_all script. To

install the software, type:

prompt# ./install_all

This script will ask you a number of yes-or-no questions

(generated by Sun's pkgadd install script). Answer

these questions appropriately.

7. Reboot the system to complete the installation.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Pas de commentaire

Tech-source GFX 400 Series Manuel d'utilisateur Page 15