Tech-source Raptor DL-Lite Drivers for Solaris Manuel d'utilisateur télécharger pdf (Page 21)

4-1

Chapter 4

OPENWINDOWS

4.1 Overview

This section describes how to start up OpenWindows on the

Raptor cards. The examples in this chapter use rapdlt0 as the

device name but the device name of your card may be different

depending on the instance number.

4.1.1 Raptor as the Console

If the Raptor is the console, type:

prompt# openwin

4.1.2 Raptor as the Secondary Framebuffer

If the PGX (Sun Microsystem’s on board video card) card is the

console and the Raptor is the second card, to start OpenWindows

on both cards, in multi-screen mode, type:

prompt# openwin -dev /dev/fbs/m640 \

-dev /dev/fbs/rapdlt0

The assigned OpenWindows screen numbers correspond to the

order of the devices on the command line.

NOTE: In the above example, the raptor device instance

number is 0. This may be different in your configuration. Please

check in /dev/fbs/ or dmesg for the correct device instance

numbers on your system.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Pas de commentaire

Tech-source Raptor DL-Lite Drivers for Solaris Manuel d'utilisateur Page 21