Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur télécharger pdf (Page 10)

Raptor Drivers for HP-UX Installation and Reference Manual

2-2

Step 2: Install the Raptor card firmly into the PCI Local Bus

slot. Take care to press it evenly and snugly into

the slot. Once you are certain the card is installed

properly in the slot, secure it with the bracket

screw.

Step 3: Secure the system’s cover, attach any previously

removed cables, and connect the video cable to

your monitor.

The Raptor card is now installed and the system is ready for software

installation as discussed in Chapter 3. If installing a display

subsystem (one of the Raptor FPS products), please read Section

2.3.

NOTE: At most, one Raptor card can be installed in a 64-bit PCI slot

on a HP C-360 workstation. If multiple Raptor cards are required,

install remaining cards into 32-bit slots.

2.3 Raptor 2100/2500 FPS Installation

Figure 2-1 – Raptor 2100 Digital Flat Panel Subsystem

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Pas de commentaire

Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur Page 10