Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur télécharger pdf (Page 15)

Chapter 3 - Software Installation

3-3

9. Follow the on-screen instructions to complete installation. If any

warnings or errors are reported, check the Logfile (default:

/var/adm/sw/swagent.log), correct the errors, then

continue.

3.2.2 Installation on HP-UX 11.0

The following are step-by-step instructions for installing the Raptor

Drivers for HP-UX 11.0 software from a CD-ROM.

1. Install a supported Raptor card in the HP workstation/server, and

boot the system.

2. Log in as root on the target system, using /sbin/sh as your

shell.

3. Uninstall any previous version of Raptor software in accordance

with the instructions supplied with that software.

4. Insert the CD-ROM labeled “Raptor Drivers for HP-UX" into the

drive.

5. Run swinstall. Accept all the path defaults.

6. The swinstall program will automatically try to locate, mount,

and read any CD-ROM device present. If the program is

successful, it will display TSIRDHPUX_11 and TSIFTHPUX_11.

If this is not displayed, please proceed to the section titled,

“Mounting the CD-ROM Manually.” See Section 3.2.4.

7. Move the cursor down to the desired package and highlight it by

pressing <space>.

NOTE: You only need to install the packages for the graphics card

that you wish to use.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Pas de commentaire

Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur Page 15