Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur télécharger pdf (Page 18)

Raptor Drivers for HP-UX Installation and Reference Manual

3-6

(Replace /dev/dsk/c1t2d0 with your device file from step 3.)

5. Verify that you can read the CD-ROM.

# ls /CD-ROM

6. Initiate "swinstall" and specify your mount point as the

source depot.

# swinstall -s /CD-ROM

7. Move the cursor down to the desired package and highlight it by

pressing <space>.

8. Press <tab> to activate the menu bar. Move the cursor across

to 'Actions' and press <Enter>. Move the cursor down to

'Install (analysis)' and press <Enter>.

9. Follow the on-screen instructions to complete installation. If any

warnings or errors are reported, check the Log file (default:

/var/adm/sw/swagent.log), correct the errors, then

continue.

3.3 New Devices

One new device name is created in the /dev directory for each

Raptor card. It is denoted by raptor# for the Raptor 2000 card,

where # represents an instance number assigned by the operating

system. The device names for the other products are enumerated

below:

Raptor 2100T rap2kt#

Raptor 2500T-DL raptfp#

Raptor 1100T raplkt#

If the Raptor card was not present in the system during software

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Pas de commentaire

Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur Page 18