Tech-source Raptor OpenWindows for Solaris Manuel d'utilisateur télécharger pdf (Page 48)

Raptor OpenWindows for Solaris Installation and Reference Manual

A-4

30 1600x1200x65

31 1600x1200x70

32 1600x1200x75

33 1600x1200x85 +

34 1600x1280x76 *

NOTE: The resolutions followed by an * use composite sync.

The resolutions followed by a + are not supported on the Raptor

1100T.

Use nvedit to set the video-mode variable in NVRAM to the

number that corresponds to the desired video mode in the

preceding table. For example, to set video-mode to 8 on the

Raptor 1000 (1024x768x60), type the following:

NOTE: Please refer to Appendix B for a description of nvedit

commands.

ok nvedit

0: 8 value video-mode

1: <ctrl-c>

ok nvstore

ok setenv use-nvramrc? true

ok reset

NOTE: The last three commands enable the NVRAM. Without

these lines, the changes you make with nvedit will be ignored.

A.4 Video-Timing Method

If the previously described method fails for your configuration, it

is possible to specify the exact timing numbers for a particular

resolution. This method for setting the console resolution also

uses nvedit. This method is more involved and requires

knowledge of all timing parameters for the desired resolution,

and is only meant for monitors whose resolutions are not

available in the Video-Mode Method.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 67 68

Pas de commentaire

Tech-source Raptor OpenWindows for Solaris Manuel d'utilisateur Page 48