Tech-source Raptor OpenWindows for Solaris Manuel d'utilisateur télécharger pdf (Page 51)

Appendix A - Changing the Console Resolution

A-7

Use nvedit to remove the video-timing variable from

NVRAM using the following procedure:

1. Type nvedit at the ok prompt in Boot PROM mode.

2. Use <Ctrl-n> to move to the next line until the cursor is on

the line where video-timing is defined.

3. Type <Ctrl-u><Ctrl-k> to delete the line.

4. Type <Ctrl-c> to exit the nvedit editor.

5. Type nvstore to save the changes.

6. Type setenv use-nvramrc? true to enable the

NVRAM.

7. Type reset-all to restart the system.

This procedure can also be used to remove the video-mode

variable if necessary.

See Appendix B for more information on nvedit commands.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Pas de commentaire

Tech-source Raptor OpenWindows for Solaris Manuel d'utilisateur Page 51