Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur télécharger pdf (Page 19)

Chapter 3 - Software Installation

3-7

installation, or if for some other reason the device nodes are not

created, or if any Raptor cards are added to or removed from the

system after the software has been installed, then the Raptor drivers

must be reconfigured in order to create the proper device nodes

under /dev (i.e. /dev/raptor0, /dev/rap2kt1, etc.). To

reconfigure the Raptor drivers, issue the following two commands:

On HP-UX 10.20:

For Raptor 2000 cards:

# swconfig -u TSIRDHPUX_10

# swconfig TSIRDHPUX_10

For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:

# swconfig -u TSIFTHPUX_10

# swconfig TSIFTHPUX_10

On HP-UX 11.0:

For Raptor 2000 cards:

# swconfig -u TSIRDHPUX_11

# swconfig TSIRDHPUX_11

For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:

# swconfig -u TSIFTHPUX_11

# swconfig TSIFTHPUX_11

On HP-UX 11i:

For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:

# swconfig -u TSIFTHPUX_11i

# swconfig TSIFTHPUX_11i

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Pas de commentaire

Tech-source Raptor Drivers for HP-UX Manuel d'utilisateur Page 19